Aseptic room, also known as inoculation room, is a special laboratory for aseptic operation such as systematic inoculation and purification of bacteria. In the microbial work, the inoculation and transplantation of bacteria is a major operation. The characteristics of this operation are to ensure the purity of strains and prevent the contamination of miscellaneous bacteria. In the air of general environment, because of the existence of many dust and miscellaneous bacteria, it is easy to cause pollution, which greatly interferes with the vaccination work. Xiaojie introduces the standardization of decoration design of microbial aseptic room for you.
Aseptic room should be set up according to the principle of economy and science. The basic requirements are as follows:
(1) The aseptic room should have internal and external rooms. The inner room is the sterile room and the outer room is the buffer room. Room volume should not be too large to facilitate air sterilization. The inner area is 2 × 2.5 = 5m2, and the outer area is 1 × 2 = 2M2. The height should be less than 2.5m, and there should be ceiling.
(2) Sliding door should be set in the inner room to reduce the air fluctuation. The door should be set at the farthest position from the working table; the door of the outer room should also use the sliding door, which should be set at the farthest position from the inner room.
(3) A small window should be opened on the wall or "partition" separating the internal and external rooms, which is necessary for the internal and external transmission of articles during the inoculation process, so as to reduce the number of people entering and leaving the inner room and reduce the pollution degree. The window is 60cm in width, 40cm in height and 30cm in thickness.
(4) The volume of aseptic room is small and tight. After using for a period of time, the indoor temperature is very high, so ventilation window should be set. The ventilation window should be set on the ceiling at the entrance of the inner room (i.e. the farthest position from the working table). It is better to have a double-layer structure. The outer layer is made of louvers, and the inner layer can be made of draw plate window fans. The ventilation window can be opened after the inner chamber is used and before sterilization to circulate air. If possible, constant temperature and humidity machine can be installed.
The above will say that aseptic room decoration introduces some basic points of decoration design for you. For more details, please pay attention to our official website: http://www.nexregen.com